Maintenance-Free Battery
Your vehicle is equipped with a maintenance-free battery.
You will never have to add water, nor is periodic maintenance required.
NOTE:
The battery is stored in a compartment behind 
the left front fender and is accessible without removing 
the tire and wheel. Remote battery terminals are located 
in the engine compartment for jump-starting. Refer to 
“Jump-Starting Procedures” in “What To Do In Emergencies” 
for further information.
To access the battery, turn the steering wheel fully to the right and remove the inner fender shield.
WARNING!
• Battery fluid is a corrosive acid solution and can 
burn or even blind you. Do not allow battery fluid 
to contact your eyes, skin, or clothing. Do not lean 
over a battery when attaching clamps. If acid 
splashes in eyes or on skin, flush the area immediately 
with large amounts of water.
• Battery gas is flammable and explosive. Keep flame or sparks away from the battery. Do not use a booster battery or any other booster source with an output greater than 12 Volts. Do not allow cable clamps to touch each other.
• Battery posts, terminals, and related accessories contain lead and lead compounds. Wash hands after handling.
CAUTION!
• It is essential when replacing the cables on the 
battery that the positive cable is attached to the 
positive post and the negative cable is attached to 
the negative post. Battery posts are marked positive 
(+) and negative (-) and are identified on the 
battery case. Cable clamps should be tight on the 
terminal posts and free of corrosion.
• If a “fast charger” is used while the battery is in the vehicle, disconnect both vehicle battery cables before connecting the charger to the battery. Do not use a “fast charger” to provide starting voltage.
See also:
Using The Remote Control
   1. Press the MODE button on the Remote Control and 
the Mode Select Screen will display, unless a video is 
playing then only a small banner will appear on the 
bottom of the screen.
2. While look ...
   
Memory Position Recall
   NOTE:
The vehicle must be in PARK to recall memory 
positions. If a recall is attempted when the vehicle is not 
in PARK, a message will be displayed in the EVIC.
To recall the memory settings for ...
   
Turning Confirmation Prompts ON/OFF
   Turning confirmation prompts off will stop the system 
from confirming your choices (e.g., the Uconnect™ 
Phone will not repeat a phone number before you dial it). 
• Press the button to begin. ...
   
