Language Selection


 

To change the language that the Uconnect™ Phone is using:

• Press the • After the “Ready” prompt and the following beep, say button to begin.

• After the “Ready” prompt and the following beep, say the name of the language you wish to switch to English, Espanol, or Francais.

• Continue to follow the system prompts to complete the language selection.

After selecting one of the languages, all prompts and voice commands will be in that language.

NOTE:
After every Uconnect™ Phone language change operation, only the language-specific 32-name phonebook is usable. The paired phone name is not languagespecific and is usable across all languages.

    See also:

    Before You Begin Programming HomeLink
    Be sure that your vehicle is parked outside of the garage before you begin programming. For more efficient programming and accurate transmission of the radio-frequency signal it is recommended th ...

    Trip Info
    Press and release the UP or DOWN button until “Trip Info” is highlighted in the EVIC and press the SELECT button. Press and release the UP/DOWN buttons to highlight one of the following func ...

    To Turn Off The Engine While In Remote Start Mode
    Press and release the REMOTE START button one time or allow the engine to run for the entire 15 minute cycle. NOTE: To avoid unintentional shutdowns while in the Remote Start Mode, the system wi ...