Seat Belts


 

Inspect the belt system periodically, checking for cuts, frays, and loose parts. Damaged parts must be replaced immediately. Do not disassemble or modify the system.

Front seat belt assemblies must be replaced after a collision. Rear seat belt assemblies must be replaced after a collision if they have been damaged (i.e., bent retractor, torn webbing, etc.). If there is any question regarding belt or retractor condition, replace the belt.

    See also:

    Rear Temperature Control
    The rear mode selection REAR, allows the settings to be controlled by the rear mode control knob. To change the temperature in the rear of the vehicle, rotate the temperature control knob counter ...

    Media Center 130 With Satellite Radio (Sales Code RES+RSC).
    NOTE: The radio sales code is located on the lower right side of the radio faceplate. Media Center 130 (RES/RSC) ...

    Blind Spot Monitoring — If Equipped
    The Blind Spot Monitoring (BSM) system uses two radarbased sensors, located inside the rear bumper fascia, to detect highway licensable vehicles (automobiles, trucks, motorcycles, etc.) that ent ...