Operation

Voice commands can be used to operate the Uconnect™ Phone and to navigate through the Uconnect™ Phone menu structure. Voice commands are required after most Uconnect™ Phone prompts. You will be prompted for a specific command and then guided through the available options.

• Prior to giving a voice command, one must wait for the beep, which follows the “Ready” prompt or another prompt.

• For certain operations, compound commands can be used. For example, instead of saying “Setup” and then “Pair a Device”, the following compound command can be said: “Pair a Bluetooth Device”.

• For each feature explanation in this section, only the compound form of the voice command is given. You can also break the commands into parts and say each part of the command when you are asked for it. For example, you can use the compound form voice command “Phonebook New Entry”, or you can break the compound form command into two voice commands:

“Phonebook” and “New Entry”. Please remember, the Uconnect™ Phone works best when you talk in a normal conversational tone, as if speaking to someone sitting a few feet/meters away from you.

See also:

To Set A Desired Speed
Turn the Electronic Speed Control ON. When the vehicle has reached the desired speed, press the SET (-) button and release. Release the accelerator and the vehicle will operate at the selected s ...

Engineered to Provide Drivers an Exhilarating Open-air Driving Experience
From the ground up, the new 2011 Chrysler 200 Convertible has been redesigned and upgraded to deliver great American design and engineering, with a value proposition that exceeds expectations. The ...

To Unlatch The Trunk
Press the TRUNK button on the RKE transmitter two times within five seconds to unlatch the trunk. If the vehicle is equipped with Passive Entry, refer to “Keyless Enter-N-Go” under “Things ...